Serial Port Hardware Specs

One of the Newton 2.x OS Q&As
Copyright © 1997 Newton, Inc. All Rights Reserved. Newton, Newton Technology, Newton Works, the Newton, Inc. logo, the Newton Technology logo, the Light Bulb logo and MessagePad are trademarks of Newton, Inc. and may be registered in the U.S.A. and other countries. Windows is a registered trademark of Microsoft Corp. All other trademarks and company names are the intellectual property of their respective owners.


For the most recent version of the Q&As on the World Wide Web, check the URL: http://www.newton-inc.com/dev/techinfo/qa/qa.htm
If you've copied this file locally,click here to go to the main Newton Q&A page.
This document was exported on 7/23/97.


Serial Port Hardware Specs (4/9/97)

Q: What are the hardware specifications for the serial port?

A: In the Apple MessagePad 100, 110, 120, 130, 2000, the eMate 300, the Sharp ExpertPad, and the Motorola Marco, the serial port is an EIA standard RS-422 port with the following pinout (as viewed looking at the female Mini-DIN-8 socket on the side of the Newton device, or looking at the female Mini-DIN-9 on the Newton Serial Adapter):

<see diagram>

Pin 1    HSKo                /DTRPin 2    HSKi                /CTSPin 3    TxD-                /TDPin 4    GND                Signal ground connected to both logic and chassis ground.Pin 5    RxD-                /RD Pin 6    TxD+                (see below)Pin 7    GPi                General purpose input received at SCC's DCD pin.Pin 8    RxD+                (see below)Pin 9 Power out          5V@100ma.  This pin only exists on the eMate 300 and the Newton Serial Adapter.


All inputs are:
Ri 12K ohms
minimum Vih 0.2v, Vil -0.2V
maximum tolerance Vih 15V, Vil -15V

All outputs are:
Rl 450 ohms
minimum Voh 3.6V, Vol -3.6V
maximum Voh 5.5V, Vol -5.5V

No more than 40mA total can be drawn from all pins on the serial port. Pins 3 & 6 tri-state when SCC's /RTS is not asserted.

The EIA RS-422 standard modulates its data signal against an inverted (negative) copy of the same signal on another wire (twisted pairs 3/6 & 5/8 above). This differential signal is compatable with older RS-232 standards by converting to EIA standard RS-423, which involves grounding the positive side of the RS-422 receiver, and leaving the positive side of the RS-422 transmitter unconnected. Doing so, however, limits the usable cable distance to approximately 50 feet, and is somewhat less reliable.

The MessagePad 120 and the MessagePad 130 use a Linear Technology LTC902 serial line driver. This part drives +5/-5 nominally for the RS422 signals, and you can use just one half to interconnect with RS232 compatible signal levels.

The MessagePad 2000 and the eMate 300 use a Linear Technology LTC1323 serial line driver. This part drives +5/-5 nominally for the RS422 signals, and you can use just one half to interconnect with RS232 compatible signal levels.
Q&A Diagram